Listed in: Extreme Series

Mini Arctic Challenge 130

Art.No.: 7-130-0

This is the tender to the Mini Arctic Challenge 160 (MAC160)
Raw state of the art design, ultra light weight that’s all it is.
This pulk is basically confectioned to support the MAC 160 in the first
part of the expedition, when the total payload is still very heavy and has a
lot of volume. Too much for only the MAC 160 and too much for the heavy screw
ice barriers. Polar legend Børge Ousland tested it, and no doubt, the results show that is
significantly lighter to drag the payload through screw ice barriers distributed on 2 pulks
rather than only one very large and heavy pulk. Ever since, this 2 pulk system became the standard for successful expeditions on the Arctic Ocean.
The heavier one pulk would be, the more sense it makes to distribute the load on two pulks.
So in the beginning of an expedition, the payload is highest.
After a few weeks the volume and payload has decreased that it can be more efficient
to only continue with one pulk further on.
The expedition gets lighter also with the lost weight of this extra pulk.
From this point on the expedition will move even faster.
A fine calculation will enable teams or solo expeditions to get faster to the goal.
As well as in the MAC160, concave side-walls with the multiaxial layup, strengthens the body at lowest weight balance The high-tech resin system used requires post-cure tempering. The well known (ACAPULKA typical)  round and high-drawn front section provides both strength and tremendous gliding abilities through tough screw ice ridges.
The new bottom design is as in the MAC 160.Made for minimum friction.
This is a revolutionary new design, proven on expeditions since 2005.
In 2014 the bottom got an update. Its now fitted with our new special high modular conductive surface and the new runner system STSR .
The pulk has like all other extreme series pulks a cover made of ultra light ripstop nylon.
Tie down straps for load securing that are riveted to the body.
As standard this pulks is calculated with the lowest weight. Please contact us to discuss whether there should be build in reinforcements. It may also be the case that we can build this pulk even lighter! So talk to us!

5-000-0Expedition and Backcountry 
5-100-0"Scandic Tour 100"469
5-120-0„Scandic Tour 120"559
5-135-0"Expedition Tour 135"689
5-150-0„Scandic Tour 150"689
5-170-0"Scandic Tour 170" 939
5-180-0"Windrider 180"1139
5-210-0„Scandic Tour 210"1009
6-120-0Kevlar Short Track 120 989
6-135-0Jetstream 1351269
6-150-0Trailrunner 150 1269
6-180-0Katabatic 1803079
6-210-0Standard Expedition 210 2169
7-100-0Ultra 1001119
7-120-0Feather Light 120 1259
7-130-0MAC 1303299
7-135-0Delta Force 1351559
7-150-0Feather Light XL 150 1559
7-160-0MAC 1605299
7-170-0Polar Challenge 170 2759
7-180-0Dragonfly 1804249
7-210-0Professional Expedition 210 3289
7-215-0Børge Ousland Expedition 2154249
7-230-0Arctic Challenge 2306259
7-310-0Icecap Xpress3919
7-260-0Trans Antarctic Challenge 250 (The longest march, Rune Gjeldnes)7399
910-238Randonnee Alpine Backpack with D ring "pullpack" 38L NEW 2017159
910-243Randonnee Alpine Backpack with D ring "pullpack" 43L NEW 2017169
910-3Dragging Bar Wire System, separable in Stuffsack199
910-34Glideboard set269
910-4Waist harness69
910-5Shoulder straps in connection with waist harness75
910-6Complete Harness set129
910-61Heavy Duty Harness/expedition harness139
910-7Transport Bag 120 cm models145
910-8Transport Bag 150 cm models175
910-9Transport Bag 210 cm + models199
920-0Spare Parts 
920-0Drag fittings incl. Screws ( pair)49
920-1Aluminium bar69
920-2Tube short for dragging bar 910-328
920-3Tube long for dragging bar 910-330
920-4Straphook connection between harnesses shoulder/waist13
920-5Carbine hook stainless steel12
920-6Wire incl. swage terminals49
920-7Eye Bolt 9
920-8Interface glideboard set15
920-9STSR Runner complete incl. Mounting rail 253 cm long, 1 piece151
920-91Runner STSR 100-170 cm pulks , pair92
920-92Runner STSR 180-260 cm pulks , pair184

Download Pricelist

    nameMAC 130
    weight 3,5 kg minimum
    length 130 cm
    max. width 60 cm
    volume > 300 l
    construction handmade monocore multiaxial
    construction, vacuum processed
    body Partly black-magic coating
    Kevlar fibers
    epoxy resins
    color: yellow/black
    cover Superlight RS with zipper or Velcro
    tightening straps
    upstanding lift loops
    color: optional/standard red
    dragging bar/rope pickup HD webbing strap
    runners STSR runners, replaceable
    art. no. 7-130-0


The most important thing is that the equipment works as it should, out there.
That’s our main focus!

If you have any suggestions please do not hesitate to contact us!
More about us

Contact international

icon+47 / 359 581 86 // 9am-6pm UTC  weekdays  

icon+47 / 359 581 12

Please publish modules in offcanvas position.